Filter
Top Products
6 Pelco Manual C546M (8/98)
3.0 INSTALLATION
3.1 HARDWARE
3.1.1 Card Expansion Installation
Each port expander card has its own microprocessor and power regulator. No
communication exists between port expander cards.
Cards are installed from the front of the unit after the quick-disconnect screws which
hold the front panel in place are loosened (refer to Figure 2).
Cards can be installed into any free slot in the CM9760-PEX Port Expander; that is,
there is no set position where the first card must be installed. The five
Input Ports
located on the right rear of the unit, however, are associated with specific physical
card expansion positions as indicated in Figure 1.
Figure 2. CM9760-PEX Front View with Card Installation