Filter
Top Products
C2487M-B (11/05) 37
6. The blanked area can be programmed to turn on or off at a specified zoom point. To set
the zoom point:
a. Use the joystick to position the cursor beside EDIT WINDOW ZOOM, and then
press Iris Open.
b. Zoom in to the point where you want window blanking to turn on. Press Iris Open
to set the zoom point.
NOTE: Since the area is already blanked out, it may be difficult to determine when you
want window blanking to turn on. Reverse the window before setting the zoom point.
When finished reverse the window again to blank out the area.
Window Blanking Disabled Window Blanking Enabled
(See page 11)
Quick Programming Guide
NOTE: Increase the size of the window if any part of the blanked area is revealed during pan,
tilt, and zoom operations.
*This setting only applies to
Pressurized Spectra III dome
systems with software version
1.27 or higher.
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
BACK
EXIT
DOME SETTINGS
BACK
EXIT
STYLE GRAY
BLANK ALL ABOVE OFF
BLANK ALL BELOW OFF
<SET WINDOW>
WINDOW BLANKING
BACK
EXIT
SET WINDOW
WINDOW NUMBER 1
<EDIT WINDOW LOCATION>
<EDIT WINDOW ZOOM>
ENABLE WINDOW NO
REVERSE
CLEAR WINDOW