Filter
Top Products
30 C2443M-D (11/05)
Presets
The Spectra III SE dome system has 150 preset positions. Each of the user-definable presets can
be programmed to use pan, tilt, camera settings, and motion detection. The programmable
presets are numbered 1-32, 35-82, and 100-150.
The following presets are predefined for specific functions:
Preset Action
33 Flip command. Pans the dome drive 180 degrees.
34 Pan zero command. Directs the dome drive to the factory-
determined zero reference point.
83-89 Reserved.
90-91 Manual limit stops.
92-93 Scan limit stops.
94 Reserved.
95 Select main programming menu.
96 Stop a scan.
97 Random scanning.
98 Frame scanning.
99 Start auto scanning.
Use the following steps to program a preset.
1. Select the preset number:
a. Use the joystick to position the cursor beside PRESET NUMBER. Press Iris Open.
The cursor moves to the right.
b. Move the joystick up or down to view selections. Press Iris Open to enter
selection.
2. Edit the preset label:
a. Use the joystick to position the cursor beside EDIT PRESET LABEL.
b. Press Iris Open. The following appears on the monitor:
c. Use the joystick to position the cursor beside a character. Press Iris Open to enter
selection. To clear a character, position the cursor beside BACKSPACE, and then
press Iris Open.
d. When label is completed, move the cursor to OK. Press Iris Open to return to the
Preset menu.
PRESET NUMBER 1
* * * PRESET NOT DEFINED * * *
<EDIT PRESET LABEL>
<EDIT PRESET SCENE>
<EDIT CAMERA SETTINGS>
<CLEAR PRESET>
<CLEAR CAMERA SETTINGS>
BACK
EXIT
REFERENCE INFORMATION
AZIMUTH -
ELEVATION -
ZOOM RATIO -
CUSTOM CAMERA SETTINGS -
PRESETS
<CAMERA>
<MOTION>
<POWER UP>
<LINE SYNC>
<PRESETS>
<PATTERNS>
<ZONES>
<WINDOW BLANKING>
<ALARMS>
<AUX>
<TITLE TEXT>
<ALERT>*
<CLEAR>
<PASSWORD>
BACK
EXIT
DOME SETTINGS
LABEL FOR PRESET
PRESET NUMBER
------
1234567890 OK
ABCDEFGHIJ CANCEL
KLMNOPQRST
UVWXYZ.,-/ SPACE
abcdefghij BACKSPACE
klmnopqrst
uvwxyz#&:*
EXIT
SPECTRA III
LANGUAGE ENGLISH
<SYSTEM INFORMATION>
<DISPLAY SETUP>
<DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
*This setting only applies to
Pressurized Spectra III SE dome
systems with software version
1.25 or higher.