Pelco DX4800 Security Camera User Manual


 
C4655M (2/11) 63
UPDATE
The update feature allows you to upgrade HVR software. The current HVR configuration settings are not deleted or replaced during the update
process. You can perform an update from either a local or a network location.
The unit allows you to configure the following settings:
Method: Allows you update the software from a local or network location. If NETWORK is selected, the FTP server’s IP address must be
provided.
Device: Allows you to updated the software from a DVD or USB device.
If updating from a USB device:
All USB devices, except the USB device containing the update file, must be disconnected before you can attach the USB drive.
Format the USB drive using the HVR erase media utility before starting the update process.
If the system cannot find a valid update file, the “Cannot find valid update file.” message appears. Verify that a valid update file is
located in the USB device’s root directory, and then repeat the procedure.
If the system finds a valid update file, the “S/W update is in progress.” message appears.
FTP Server: Allows you to enter the FTP server’s IP address. The box is available if the Method setting is NETWORK.
If updating from a network server:
The HVR network settings must be configured.
If the update server IP address is not configured, the “Change update server to Update Server for all entries.” message appears.
If the incorrect update server IP address is configured or the system cannot located the update server, the “Update Server access
failed.” message appears.
If the system finds a valid update server and file, the “S/W update is in progress.” message appears. The unit must be turned on,
connected to a network, and you must be logged on at the administrator level to update the HVR. The HVR will restart to complete the
update; therefore, do not update the HVR unless unit recording can be interrupted.
Search: Searches the configured device or FTP server to locate the update file (<filename>.sh).
Updating from a USB Device
To update the unit’s software from a USB device:
1. Reformat a USB device on the DX4700/DX4800.
2. Remove the USB device, and copy the update file to the device.
3. Insert the USB device into the unit.
4. From the System menu, click the Update submenu.
5. Verify that the Method box is set to LOCAL.
6. Click the Device box, and then select the USB device.
7. Click Search. The update file appears in the search table.
8. To update the unit’s software, click Update. The Update dialog box appears.
9. Click OK. The “Please wait” message appears. After a few minutes, the “Restart the system” message appears.
10. Click OK. The unit restarts, displays the startup screen, and then displays the application window.