Filter
Top Products
Pelco Manual C1423M-D (10/03) 7
11. Thermostatically Controlled Operation Only (O/I-PCB Installed) - If the
circuit board for thermostatic control of the fan already is installed, complete
the installation as follows:
a. Remove the plastic power supply barrier cover from the circuit board.
b. Connect the plug from the fan into the FAN socket on the circuit board.
c. Replace the plastic power supply barrier cover.
d. Reinstall the camera and sled.
e. Close the enclosure lid.
f. The fans in the BK57-1 and BK57-3 blower kits use 15 watts of power. The
fan in the BK57-2 blower kit uses 10 watts of power. Make sure the wiring
that supplies power to your enclosure can handle this additional wattage.
g. Turn on power.
12. Thermostatically Controlled Operation Only (O/l PCB Not Installed) - If
the circuit board for thermostatic control of the fan is not installed, follow the
steps in Section 6.0, CIRCUIT BOARD KIT INSTALLATION, to complete the
installation.