Filter
Top Products
Pelco Manual C411M-D (1/96) 5
4.3 FIXED ENCLOSURE MOUNTING
The are two types of mounts that can be used with the
EH66 enclosure: wall, or pedestal/ceiling (see Figures
3 and 4).
Instructions for mounting the enclosure are as follows:
1. Select the appropriate mount (WM2000 for wall
mounting or PM2000/PM2010 for pedestal mount-
ing) for the application.
The mount must be equipped with the AH2000
adjustable head for precise positioning of the en-
closure.
2. Secure the mount to a suitable load bearing
surface. Use fasteners with a minimum 1/4-inch
diameter.
Figure 4. EH66 Enclosure with
Pedestal/Ceiling Mount
3. Attach the adjustable head to the mount.
4. Align the 1/4-20 threaded holes in the bottom of the
EH66 enclosure with the holes in the tilt table of the
adjustable head. Fasten the enclosure to the table
using 1/4-20 fasteners (not to exceed 5/8" in length,
minimum two (2).
5. If you have not already done so, install the camera/
lens according to the instructions in Section 4.2 of
this manual.
6. Make all necessary electrical connections.
7. Position the enclosure to the desired viewing angle
and tighten all fasteners.
Figure 3. EH66 Enclosure with Wall Mount