Filter
Top Products
Pelco Manual C306M-K (4/05) 31
Symptom: No video or poor video
1. Check the video and power connections to the camera.
2. Check for power to the camera from the Esprit system camera power output.
3. Check all coax BNC connectors from the camera to the monitor.
4. Make sure the controller is set for the correct camera-to-monitor viewing combination;
for example, Camera 1 to Monitor 1. Refer to the controller manual for information.
5. Check for normal load termination of 75 ohms. When looping through VCRs or multi-
plexers, make sure the signal is terminated at the end device. Some termination symp-
toms and problems are listed below.
Symptom Problem
Extremely bright video No termination or high resistance
Over contrast or contrast
level of monitor needs to
be increased to maximum
for a good video image Double termination (37.5 ohms)
MAINTENANCE
Clean the enclosure window periodically with a mild non-abrasive detergent in water and a
soft cloth to help maintain picture clarity.
If operating problems are experienced with the system, refer to the
Troubleshooting
section.
The pan and tilt is IP 66 and NEMA 4X certified. The pan and tilt left side cover must be re-
moved to gain access to the DIP switches. When the cover is correctly reinstalled, the certi-
fication will remain in effect.
Since there are no user-serviceable parts in the Esprit system, if further maintenance is re-
quired, it is recommended that the Pelco Customer Service Department be contacted for
assistance. Refer to the
Warranty and Return Information
section.
NOTE:
The system con-
tains no user-serviceable
parts. If there is a problem
with your system, it must be
returned to Pelco for
servicing.