Filter
Top Products
8
This section describes the procedures for installing the USB driver
and the necessary software.
Two drivers (PENSSTOR.INF and PENSPDR.INF) must be installed
before using the USB cable to connect the camera to a computer
running Windows 98/98SE.
1 Turn your PC on.
2 Insert the CD-ROM (S-SW22) into the CD-ROM drive.
The PENTAX Software Installer screen appears automatically, but
no action is required at this stage.
3 Make sure the camera is turned off and connect it to
your PC with the USB cable.
Make sure the SD Memory Card is inserted in the camera.
4 Turn your camera on.
Your PC will automatically detect the camera as new hardware and
the Wizard screen will appear.
Installing the USB Driver and the Software (for
Windows)
Installing the Image Processing Software (ACDSee for PENTAX) 1p.11
Installing the USB Driver on Windows 98/98SE only
If you are using Windows 2000, Windows Me or Windows XP, you
do not need to install the USB driver. Go to “Installing the Image
Processing Software (ACDSee for PENTAX)” (1p.11)