Filter
Top Products
175
9
Appendix
Subject is not in
focus
Subject is difficult to
focus on with
autofocus
Lock focus on another object located at
same distance (press shutter release
button halfway), then aim at target and
press shutter release button fully (p.41),
or use Manual Focus mode. (p.82)
Subject is not in
focusing area
Position subject in focus frame in middle
of LCD monitor. If the subject is outside
the focusing area, aim the camera at the
subject and lock the focus (press shutter
release button halfway), then compose
picture and press the shutter release
button fully.
Subject is too close Set focus mode to q. (p.81)
Focus mode is set to q
Normal pictures will be out of focus if
taken with focus mode set to q.
Flash does not
discharge
Flash mode is set to a
(flash off)
Set to Auto or b (Flash On). (p.83)
Drive mode is set to 1
or c
Focus mode is set to
s
Shooting mode is set
to C or y
Flash will not discharge in these modes.
USB connection
with computer
does not work
properly
USB connection mode
is set to [PictBridge]
Change the USB connection mode to
[PC]. (p.159)
USB connection
with printer does
not work properly
USB connection mode
is set to [PC]
Change the USB connection mode to
[Pictbridge]. (p.139)
Problem Cause Remedy