Filter
Top Products
Appendix A: Restore Factory
Default Settings
There is a switch hidden in the pinhole under the bottom of Network Camera. It is used
to restore the factory default settings. While the Network Camera got problem,
sometimes, restarting the Network Camera will make the system back to a normal state.
In case the system still got problems after reset, user can restore the factory default
settings and install it again.
Restore the Network Camera:
1. Power off the Network Camera.
2. Insert the paper clip or other tool and press and hold the button down
continuously.
3. Power on the Network Camera again.
4. Wait at least 10 seconds and release the tool. Then the Network Camera has
been restored to default settings.
5. Reconfigure the Network Camera
Factory
Default Reset
Note: Restoring the factory default setting will lose the all previous settings forever. User
needs to run the IP Finder program to search the Network Camera and configure it to let
the Network Camera work properly again.
45/60