Filter
Top Products
ProHead
The modelling light is turned on and off with the black switch
[1] at the back of the head. The built-in fan can easily be
switched between continuous and thermostat-controlled
operations [2]. Please note that when changing modelling
light, flash tube or glass cover the lamp cable must be
disconnected from the generator.
The modelling light has a mini-can socket (E11). The flash
tube has two metal pins. When removing a flash tube, pull it
straight out of the sockets. When inserting a new flash tube,
check that the trigger-wire clasps properly around the flash
tube (please see mounting instructions in package). When
mounting the glass cover, check that both locking springs
connect properly into glass cover holes. In case the head
overheats the modelling light automatically switches off.
When the temperature has dropped sufficiently the modelling
light will switch on again. At the back of the head there is an
opening for attaching accessories such as filters and barn doors.
There are glass covers for different colour temperatures
available.
Loosening the handle [4] can easily alter the flash head posi-
tion. An umbrella can be mounted in the umbrella holder.
The ProHead is normally delivered with a 250W modelling
lamp but can be equipped with a 500W lamp if using the
longer (100mm) glass cover used on the ProTwin.
8
10.15.33 Glass Cover, frosted, UV-coated (standard)
10.15.34 Glass Cover, frosted, uncoated, + 300° Kelvin
10.15.35 Glass Cover, frosted, extra UV-coated, - 300° Kelvin
10.15.36 Glass Cover, clear, uncoated, + 300° Kelvin
10.15.37 Glass Cover, clear, UV-coated
1
2
3
4