Manual Mode | 15
(1) Press the MODE button until you reach the manual mode. The “M” indicator will show on the LCD.
(2) Then press the “ + ” or “ - ” selector button to set your desired output. The setting will then be automati-
cally saved into the internal memory.
(3) Set your camera accordingly. For shutter speed, the highest you can set is the camera’s flash sync
speed unless you activate the High Speed Sync feature. Please refer to the section “HIGH SPEED
SYNC” for details.
(4) Make sure that your subject is within the suggested maximum flash-to-subject distance as indicated
on the LCD and take a test shot. Check the result on your camera.
(5) Adjust your camera’s setting and the level of the light output of the flash if needed.
(6) Press the camera’s shutter release button to take the picture.
MANUAL MODE
You can set the ProMaster FL1 flash’s output level manually to create special lighting effects. Seven
manual settings are available: 1/1, 1/2, 1/4, 1/8, 1/16, 1/32, and 1/64. The flash fires full power at the 1/1
setting, and each successive setting halves the light output.To use the manual mode:
To avoid overheating or damage to the flash, please wait for at least 10 minutes after making 15 continu-
ous shots at full power. Your flash will automatically shut off if overheated.