Filter
Top Products
INSTALLATION
10
consult your device’s manual if this
configuration does not apply. The power jack
on the capture card is of no concern when you
are using a device other than the NTSC
camera included in your Bigpicture kit.
To connect your device’s audio out to your
sound card, connect a phono plug to miniature
1/8-inch (3.5 mm) phone plug adapter (Radio
Shack catalog number 274-330a) to one end
of an RCA male to RCA male cable. Plug the
RCA male end of the cable into your device’s
AUDIO OUT jack. Plug the 1/8-inch plug
into the sound card’s 1/8-inch MIC or
AUDIO IN jack (refer to the sound card’s
documentation for further information).
Installing the Video Capture
Card’s Drivers
NOTE: If you wrote “950B” in the
blank on page 4, go to “Video Capture
Card Driver Installation with Windows
95 Version 950B” on page 15.
Video Capture Card Driver Installation
with Windows 95 Versions 950 and
950A
1. Turn on your computer. When Windows
restarts, it will detect the video capture
card. You should see the following screen.