Filter
Top Products
PUSH
REW F.FWD
STOP PLAY
A/V DUB PAUSE
DISPLAY
RESET
TITLE
RECORD
T
W
ZOOM
ON
OFF
S.EDIT
The remote operates the camcorder by
infrared light, so it is protected from
electrical and sound interference.
However, the remote must be aimed
directly at the camcorder’s remote
sensor. There cannot be any obstructions
between them.
Note: The camcorder may not respond to the
remote control if the camcorder’s remote
sensor is exposed to direct sunlight or strong
artificial light.
Remote Sensor
9
Remote Control
1. Turn remote over, insert a pin or
straightened paper clip in the pin hole,
and remove the battery holder.
2. Insert battery so positive (+) terminal
faces up.
3. Replace battery holder.
Notes: Never place anything heavy on top of
the remote control or lay it upside-down.
Replace battery when camcorder fails to
respond to remote.
Remove the battery from the remote if it will
not be used for a month or more. This will
prevent possible damage from battery
leakage. If leakage occurs, wipe up the liquid
inside the compartment and replace
the battery.
Install Remote Battery
Back of Remote
Battery Holder
Pin Hole
Cautions: Lithium cell battery. Must be
disposed of properly. Never handle a
punctured or leaking cell. May cause burns
or personal injury.
Keep out of the hands of children. Can
cause death or injury if swallowed. If
swallowed, consult a physician immediately
for emergency treatment.
The lithium cell used in this device may
explode resulting in a fire or chemical burn if
mistreated. Do not recharge, disassemble,
heat above 212˚F (100˚C), or incinerate.
Never use metallic tweezers to hold the cell,
and never short circuit the + and – sides of
the cell.