Filter
Top Products
148
A picture is blurred. You moved the camera when
pressing the shutter release button.
Hold the camera with your elbows tight
on your body. Or use a tripod.
P. 2 9
When shooting in a dark place (ex.
indoor), the shutter speed slows down
and pictures become easily blurred.
Use the flash. Or, raise the ISO
sensitivity.
P. 3 8
P. 7 9
The flash does not fire. Or
the flash cannot recharge.
Flashing is prohibited in the following
statuses:
- White Balance Bracket enabled
- Continuous Shooting Mode
- Movie Mode
In some Scene Modes, flashing may
be prohibited by default. (see P.156)
For shooting with the flash, change the
settings or mode.
P. 1 2
P. 6 9
P. 8 5
P. 8 9
P.156
The flash is set to Flash Off. Deselect the Flash Off with the F
button.
P. 3 8
Batteries are running low. If using alkaline batteries, replace the
batteries with a new set. If using
rechargeable batteries, recharge or use
the AC Adapter.
P. 1 6
Even though the flash
fired, the picture is dark.
The distance to the subject is greater
than 2.1 meters in Telephoto or
greater than 2.7 meters in Wide-
angle.
Get closer to your subject and shoot. P.38
The subject is dark. Correct exposure. (Exposure correction
also changes the light quantity of the
flash.)
P. 7 6
The image is too bright. The light quantity of the flash is not
appropriate.
Move a little away from the subject or
light up the subject for shooting without
flashing.
P. 3 8
It is over-exposed. Use exposure compensation. Cancel
Exposure Time.
P. 7 1
P. 7 6
The brightness of the LCD monitor is
not appropriate.
Adjust the brightness of the LCD
Monitor.
P. 11 0
The image is too dark. The shot was taken in a dark place
while set to (Flash Off).
Deselect the Flash Off with the F button. P.38
It is under-exposed. Use exposure compensation. Set to
Exposure Time.
P. 7 1
P. 7 6
The brightness of the LCD monitor is
not appropriate.
Adjust the brightness of the LCD
Monitor.
P. 11 0
The image lacks natural
color.
The picture was shot in conditions
that are hard for Auto White Balance
to adjust to.
Add a white object to the composition.
Or use a White Balance setting other
than Auto.
P. 7 7
The date, or recording
information does not
appear.
The screen display function is set to
No Display.
Press the DISP. button and switch
display.
P. 2 7
Symptom Cause Remedy
Refer
to