Filter
Top Products
25/32
FV-L200B1
User’s Guide Rev. 1.01
4.4.2 Descriptions of the Camera Control Commands
(The underline settings are the factory default settings)
Command No. Command Descriptions
10H:
MOD1[70]
[Camera function mode setting 1] Initial data: 09H
This sets the following camera function mode.
D[70]
D7 D6 D5 D4 D3 D2 D1 D0
D7: Continuous / Trigger Mode 0: Auto 1: Manual
D6: Trigger Polarity 0: Positive 1: Negative
D5: Trigger Mode 0: Edge Preset 1: Pulse Width
D4: Binning Mode 0: OFF (Normal) 1: ON (Binning)
D3: Scanning Mode 0: Full scanning 1: Partial scanning
D2 to D0: Reset Mode 000: Non-Reset 001: V-Reset
010~111: No function
(Prohibited setting. Please do not use these)
When D7 is set to “0: Auto”, a camera will detect its operational mode based on the input trigger signal.
If the input trigger signal is kept at high, the camera operates in the continuous mode, assuming the trigger polarity
is set to positive.
11H:
MOD2[70]
[Camera function mode setting 2] Initial data: 0
This sets the following camera function modes.
D[70]
D7 D6 D5 D4 D3 D2 D1 D0
D7 HD / VD direction 00H: SP2 and SP3 as inputs 01H: SP2 and SP3 as outputs
10 to 11H: (Prohibited setting. Do not set these values)
D6 to D5 Frame rate 00H: 15.3 fps 01H:7.6 fps
10H: 3.8 fps 11H: No function
D4 Smear Half Reduction 0: OFF 1: ON
D3 Function Mode 0: Trigger Mode 1: Continuous Mode
D2 to D0: Partial Scanning 000: Full scanning 001: 1/2 partial scanning
010: 1/4 partial scanning 111: Variable partial scanning
011~110: No function (Prohibited setting. Do not set these values)
Function mode is enabled when the “Continuous/Trigger” mode selection (MOD[7] is manual (set as 1).
No video output without the trigger signal input while the camera works with the trigger mode.