Filter
Top Products
29/32
FV-L200B1
User’s Guide Rev. 1.01
Command No. Command Descriptions
78H:
TESTP[70]
[Test pattern selection] Initial data: TESTP[7..0] = 00H
Sets the test pattern output from the camera.
D[7..0]
D7
D6
D5
D4
D3
D2
D1
D0
D7 to D5 No Function Always set as “000”
D4 to D0 Test pattern 00H: Video output 01H: Gray scale
02H: Horizontal ramp wave 03H: Uniform gray level
(100% white)
04H: Uniform gray level
(variable level)
05H: Color bar
06H: Vertical ramp wave Others: Black
79H:
EFFCT[7..0]
[Image effect selection] Initial data: EFFCT[7..0] = 00H
Sets the image effect.
D[7..0]
D7 D6 D5 D4 D3 D2 D1 D0
D7: Negative / Positive video selection 0: Positive image 1: Negative image
D6 No function Always set as “0”
D5 to D0:
Image effect 00H: No effect (Original) 01H: 11bit gradation
02H: 10bit gradation 03H: 9bit gradation
04H: 8bit gradation 05H: 7bit gradation
06H: 6bit gradation 07H: 5bit gradation
08H: 4bit gradation 09H: 3bit gradation
0AH: 2bit gradation 0BH: 1bit gradation
0C to 3FH: No function
(Prohibited settings. Do not set these values)
80H:
E2P[70]
[EEPROM control] Initial data: E2P[70] = 0
Sets the image effect.
D[7..0]
D7
D6
D5
D4
D3
D2
D1
D0
Note: This bit is cleared to “0” automatically by the internal processes after the execution of the command.
D7 to D2: No function Always set as “000000”
D1: Register synchronous update with the EEPROM data 0: Prohibited 1: Accept
D0: Write control to the EEPROM 0: Prohibited 1: Accept
94H:
STRB[7..0]
95H:
STRB[15..8]
96H:
STRB[23..16]
[Active time (us) for the strobe signal]
Initial data: STRB[23..0] =0, data range: 0 to 2,000,000
Sets active time for the strobe signal .