Filter
Top Products
ENGLISH
6060
Playback
Playing Back a Tape on the LCD Screen
✤ The Playback function and speaker works only in <Player> mode. ➥page 19
✤ You can monitor the playback picture on the LCD Screen.
1. Set the [Power] switch to [PLAYER].
2. Set the [Mode] switch to [TAPE]. (VP-D375W(i)/D975W(i) only)
3. Insert the tape you wish to view. ➥page 32
4. Open the LCD Screen.
■
Adjust the angle of the LCD Screen and set the brightness or colour if necessary.
5. Press the [
œœœœ
(REW)] button to rewind the tape to the starting point.
■
To stop rewinding, press the [■ (STOP)] button.
■
The Camcorder stops automatically after rewinding is completed.
6. Press the [
√√
❙❙ (PLAY/STILL)] button to start playback.
■
You can view the picture you recorded on the LCD Screen.
■
To stop the play operation, press the [■ (STOP)] button.
Adjusting the LCD Bright/LCD Colour during Playback
✤ You can adjust the LCD Bright/LCD Colour during playback.
✤ The adjustment method is the same procedure as used in <Camera> mode. ➥page 29
Adjusting the Volume
✤ When you use the LCD Screen for playback, you can hear recorded sound from the built-
in Speaker.
- Take the following steps to lower the volume or mute the sound while playing a tape on
the Camcorder.
✤ When sound is heard once the tape is in play, use the [
……
/
††
] button to adjust the
volume.
■
A volume level display will appear on the LCD Screen.
■
Levels may be adjusted from anywhere between <00> to <19>.
■
If you close the LCD Screen while playing, you will not hear sound from the speaker.
✤ When the Audio/Video cable is connected to the Camcorder, you cannot hear sound from
the Built-In Speaker and cannot adjust the volume.
5 6
60min
0:46:00:11
SP
√
[05]
01227G VPD371 UK~071 2/1/07 12:04 PM Page 60