Filter
Top Products
28
Using the camera button to adjust the camera
The STILL IMAGE / MOVIE CLIP mode function can be set up by using the camera
button.
Used for turning the camera power on / off.
If this camera isn’t operated during the specified time(about 60
SEC.), the camera power will be idle(LCD monitor : Off, Mode
dial lamp : ON ) automatically.
To use the camera again, press any of the camera buttons
except the power switch.
If there is no operation during the specified time after the idle
mode, the camera power will be turned off automatically to save
battery life.
Pressing the power button for over 2 seconds will deactivate the buzzer sound function.
If you wish to hear the buzzer sound, set the [SOUND] settings in the SETUP mode to ON.
Used for taking an image or recording audio in the
RECORDING (STILL IMAGE, MOVIE CLIP) mode.
In MOVIE CLIP mode
Pressing the shutter button down fully starts the process for
recording a movie clip. Press the shutter button once and the
movie clip is recorded for as long as the available recording
time in the memory allows. If you wish to stop recording, press
the shutter button again.
In STILL IMAGE mode
Pressing the shutter button down halfway activates the autofocus and checks the condition of the
flash. Pressing the shutter down fully takes the image and stores the relevant data regarding the
shot. If you select voice memo recording, the recording will start after storing the image data is
complete.(Voice Recording time : 10sec)
SHUTTER button
POWER switch