Filter
Top Products
COLOR CCD CAMERA User’s Manual
27
COLOR CCD CAMERA User’s Manual
26
The screen color can be adjusted by using the WHITE BALANCE function.
1. Please position the arrow to point to 'WHITE BAL' on the SETUP menu by
using the UP and DOWN buttons.
2.
Please select the mode you wish to operate by pressing the LEFT or RIGHT button.
Please select one of the 3 modes below.
ATW(Auto Tracking White Balance) : This mode can be used within the color
temperature range 1,800˚K ~ 10,500˚K (Ex. fluorescent light, outdoor, sodium
vapor lamp or inside tunnels)
AWC(Auto White Balance Control) : Please press the SETUP button while the
camera is directed at a piece of white paper to obtain the optimum state under
current illumination. If the environment including the light source is changed, you
have to adjust the white balance again.
MANUAL: The manual adjustment mode enables finer adjustment. Please select
ATW or AWC first. Please change to manual adjustment mode and press the SETUP
button. Please set the appropriate color temperature, and then increase or decrease
the red and blue color values while monitoring the color changes on the object.
WHITE BALANCE control
•Under the following conditions the WHITE BALANCE function may not operate
properly. In such cases, please select the AWC mode.
1. When the object’s surroundings have a very high color temperature.
(Ex. a clear sky and sunset)
2. When the object’s surroundings are dark
3. If the camera directly faces a fluorescent light or is installed in a place where
there are considerable changes in illumination, the WHITE BALANCE function
may become unstable.
Note
Operating Your Camera
SETUP
1.
LENS DC
SHUTTER - --
3.WHITE BAL. ATW
When there is a strong backlight behind the object, clear images of the background
as well as the object can still be obtained by using the BACKLIGHT function.
1. Please position the arrow to point to 'BACKLIGHT' on the SETUP menu by
using the UP and DOWN buttons.
2. Please select the mode you wish to operate by pressing the LEFT or RIGHT button.
SPOTLIGHT :
When the SPOT LIGHT is illuminated under the
restricted area such as entrance of the APT parking
lot or gas station, it exposes the number plate of the
automobile accurately and the efficient watch does
to be possible.
• Day Mode: The BLC function accomplishes by
SPOTLIGHT window which was set in
standard.
• B/W Mode: If both sides of the SPOTLIGHT window
be thrown bright light, monitor screen
showed up the SPOTLIGHT window.It
is possible to a subject in the center of
the image exposed correctly.
BACKLIGHT (Backlight Compensation)
SETUP
1.LENS DC
2.
SHUTTER - --
3.WHITE BAL. ATW
4.
BACKLIGHT OFF
INCIDENT SPOTLIGHT
SPOTLIGHT WINDOW
• Under ordinary circumstances, "SPOTLIGHT"
may not be operated unstably.
Note
< SPOTLIGHT ON >