Filter
Top Products
COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual
1716
Installation
3. Please remove the cover of the auto iris lens connection plug and solder the
lens cable to the connector pin in the plug.
4. Please replace the auto iris lens connection plug cover and take off the CCD
protection cap, and then attach the auto iris lens to the camera by screwing
it in clockwise.
5. Please insert the connection plug that is
connected to the auto iris lens cable into
the auto lens connector, which is located
on the side of the camera.
6. Please set the lens selection switch, located on the
side of the camera, to DC or VIDEO depending on the
type of auto iris lens which is being used.
Pin No.
LENS
DC VEDIO
No.1 Pin Damping- Red (power)
No.2 Pin Damping+ NC
No.3 Pin Drive+ White (video signal)
No.4 Pin Drive- Black (GND)
No.3 Pin
No.1 Pin
Connector
Lens cable
No.4 Pin
No.2 Pin
Please take off the CCD protection cap and attach the
C-Mount lens to the camera by screwing
it in clockwise.
1. Please take off the CCD protection cap and
C-mount adaptor.
2. Please attach the CS-Mount lens to
the camera by screwing it in
clockwise.
When using a C-Mount lens
When using a CS-Mount lens
•
Please use the specified lens connection parts as shown in the picture below.
The use of the wrong sized parts of the wrong size may cause
damage to the inside of the camera or result in poor fitting.
• Use of a lens which is too heavy affects the balance of the
camera and may cause a malfunction. Please use a lens
that weighs less than 450g.
• Please select Av mode if possible when adjusting the
automatic light control (ALC) of an auto lens. Use of PK
mode may cause hunting.
Note
C-mount lens : 10 mm or less
CS-mount lens : 5 mm or less
C-mount adaptor
C-mount adaptor
CCD protection cap
C-mount adaptor