Filter
Top Products
English _23
● OVERVIEW
Components
Item Description
a
Network Port Used to connect the PoE or Ethernet cable for network connection.
b
Alarm I/O Port
ALARM IN Used to connect the alarm input signal.
ALARM OUT
Used to connect the alarm output signal.
GND Used for earth-grounding.
c
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
d
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
a b
c
d