Filter
Top Products
appendix
78_ appendix
PROBLEM SOLUTION
I enabled Motion Detection Feature
under Motion Detection, but .jpg
files are not getting sent over FTP/
SMTP even after motion detection
occurs at the FT camera.
Verify the settings in the following sequence:
A. NTP must be properly configured.
B. Motion Detection Feature must be enabled.
C. Alarm Video Transmission must be enabled.
D. Check for scheduling conflict.
y
Is it possible to configure Motion
Zone with Motion Detection
Feature disabled?
Yes. Motion Zone can be configured independently of whether or not
Motion Detection Feature is in use.
y
A motion event took place but
didn’t trigger an alarm.
Check alarm output port settings.
y