Filter
Top Products
English _61
● SETUP SCREEN
To set the system time
Select a desired address in <Address>
or select <Synchronize with PC
viewer>.
If you select Manual, input the date and
time manually.
Click [Apply].
The specifi ed system time will be applied.
<NTP Server IP> is provided by a public agency, the list of which is subject to change from time
to time.
In a local network, a separate NTP server must be manually defi ned.
The current time can vary depending on the computers regional (GMT and DST) and country (PC
time confi guration) settings.
To check the log information
Select <System> - <Log>.
The Log information list appears.
System log list : Shows the log
information about the system changes
along with time and IP address.
System started: When the camera
turns on
User login: When the user logs in to
the camera
System restarted: When the camera restarts
Network is up: When accessing the network
Network is down: When not accessing the network
Video param. changed: When the video related parameters are changed
System time changed: When the system time is changed
Network confi guration change: When the network related confi gurations are changed
Alarm occurrence 1, 2: When an alarm is generated
Intelligent Video Analysis occurrence: When an intelligent video analysis event is
generated.
FTP send error: When FTP transfer failed
SMTP send error: When sending e-mail message through SMTP server fails.
The maximum of 2000 logs can be recorded.
If the log number is over 2000, the log in the bottom of the log list will be replaced with a new log.
1.
2.
3.
M
J
y
-
-
-
-
-
-
-
-
-
-
-
-
M