Filter
Top Products
SETTINGS
High speed electronic shutter setting
Normally, the speed setting switch for the high
speed electronic shutter set to the 0 position.
This sets the electronic shutter speed to 1/60 sec.
The switch can be set as indicated in table A to
select one of the 8 speeds available.
CAUTION:
• When using the high speed electronic shutter, the EI/AI switch
must be set to the AI position.
• Using the high speed electronic shutter indoors with low lighting,
will give darker pictures. In such a case, add some lights to make
sure the lighting is sufficient. If the lighting is very bright, pay
attention to the light angle in order to avoid or minimize the
smear phenomenon effect.
Table A
0123456 7
1/60 1/100 1/250 1/500 1/1000 1/2000 1/4000 1/10000
(Unit: sec.)
Line phase adjustment
When using a camera switcher to connect 2 cameras or more to one
monitor, there may be a vertical roll of the images when switched. In
such a case, set as described below.
1 Set the INT/LL switch to the LL position.
2 Switch the display on the monitor from camera 1 to camera 2.
Adjust the PHASE volume on camera 2 until the vertical roll of the
image stops.
If more than two cameras are used, please repeat this procedure
for all the cameras.
CAUTION:
If the vertical roll cannot be corrected by setting the PHASE volume
on camera 2, try setting the PHASE volume on camera 1. If it still
cannot be corrected, please check that the polarity of the power
cords of all connected devices is correct.
0
1
2
3
4
5
6
7
LLINT
L73Q4/US GB 2001, 6, 18
12 English