Filter
Top Products
13
• If you do not see the Digital Flash firing in the picture, set the switch
to the #3 position and repeat the above test.
• Continue moving switch down one position until you see the Digital
Flash firing in the picture – This will be your permanent pre-flash can-
cellation setting.
Note: For the above test, keep the shooting distance between the
camera and Digital Flash at about 5 feet (1.5 m). Do this test in low light
conditions, away from bright or direct light. Make sure that one of the
light sensors is exposed (not obstructed) for above test.
Important: If you are using a digital camera other than SeaLife, disable
the camera’s Red-Eye reduction. Set your camera flash to FLASH ON.
Check the camera’s instruction manual for details.
Tip: If you are using a digital camera other than SeaLife, disable the
camera’s PRE-flash, if possible. Check the camera’s instruction
manual for details. This will allow you to use the #0 pre-flash cancella-
tion setting.