Filter
Top Products
VL-AH150U/pp. 007-017; 00/11/21/18:00
G. K. Associates, Tokyo
8
Preparation
Charging the Battery Pack
1 Insert the battery pack into the VIEWCAM
(see page 7). Make sure that the Power
switch is set to OFF.
• The battery pack will not charge when the
Power switch is set to CAMERA or VCR.
2 Insert the AC plug of the AC adapter into a
power outlet.
3 Open the terminal cover on the VIEWCAM
and insert the DC plug of the AC adapter
into the DC IN jack on the VIEWCAM.
• The CHARGE indicator will light up in red.
4 When the battery is fully charged, the
CHARGE indicator will light up in green.
Remove the DC plug from the VIEWCAM,
and close the terminal cover.
Caution:
• When removing the plugs, grasp the plug, not the
cable.
Power switch
Terminal cover
DC IN jack
To power
outlet
CHARGE indicator
Charging time and maximum continuous
recording and playback times
Model VL-AH150 VL-AH160
BT-H22
180
95
95
BT-H32
360
190
190
BT-H32
360
180
180
Battery pack
Charging time
Max. continuous
recording time
BT-H22
180
90
90
Max. continuous
playback time
• The chart specifies the approximate times in
minutes.
Notes:
• Using the zoom (see page 19) and other
functions or turning the power on and off
frequently will increase power consumption.
This may result in a decrease of more than 50%
in the actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may vary
depending on the ambient temperature and the
condition of the battery pack.
• It is recommended that you have enough battery
packs on hand to provide two to three times your
estimated recording time.
• See page 58 for more information on using the
battery pack.
Caution:
• Charge only SHARP model BT-H22 or BT-H32
battery packs. Other types of battery packs may
burst, causing personal injury and damage.