Filter
Top Products
Preparation
7
Charging the Battery
Pack
1
Attach the battery pack on the
camcorder, and make sure that the
Power switch is set to OFF.
2 Open the DC IN jack cover.
3 Connect the supplied power cord
to the AC power socket on the AC
adapter, and insert the AC plug
into a power outlet.
4 Insert the DC plug into the DC IN
jack of the camcorder.
• The POWER/CHARGE (RED)
indicator lights up red.
• The POWER/CHARGE (RED) indicator
turns off when the battery is charged.
BT-L226
Charging
time
Battery
pack
Max.
continuous
recording time
Max.
continuous
playback time
on LCD
120
120 105
LCD
closed
LCD
open
105
5 Remove the DC plug from the DC IN
jack, then remove the AC adapter
from the power outlet.
Charging time and maximum
continuous recording and playback
times
• The chart specifies the approximate times in
minutes.
Notes:
• Charge the battery pack between 10°C and
30°C. The battery pack may not charge
properly at temperatures too low or too
high.
• The battery pack and AC adapter become
warm during charging. This is not a
malfunction.
• Using the zoom (see page 20) and other
functions or turning the power on and off
frequently will increase power consump-
tion. This may result in a decrease in the
actual recording time compared to the
maximum continuous recording time listed
above.
• The charging time and recording time may
vary depending on the ambient tempera-
ture and the condition of the battery pack.
• See pages 67 and 68 for more information on
using the battery pack.
• Charge only SHARP model BT-L226 battery
packs. Other types of battery packs may
burst, causing personal injury and damage.
• When attaching the supplied audio/video/S-
video cable, remove the DC plug, open the
terminal cover and connect it.
DC IN jack cover
DC plug
DC IN jack
POWER/CHARGE (RED)
indicator
AC power socket
To power
outlet