Sigma LBA-400 Digital Camera User Manual


 
Operator’s Manual LBA-PC
Doc. No. 10654-001, Rev 4.10
261
A.5.4.18 REM - go to remote
When the REM message is sent or when the LBA-PC goes from local to remote via the REN line
then local control is automatically locked out (equivalent to password lockout).
Note that remote logging (:LOG) or synchronization (:SYC) are allowed only when remote is
enabled. If remote logging was enabled in the configuration (i.e. file name was FRM, RDD, or
RDR) and you set the LBA-PC to remote, then remote logging will be re-enabled. The
synchronization state is not kept in the configuration so you must send a new SYC command
after the LBA-PC is in remote.
:REM
Returns:
REM
A.5.4.19 RUN - start running
This command has no effect if the LBA-PC is already running.
:RUN
A.5.4.20 STP - stop running
This command has no effect if the LBA-PC is already stopped.
:STP
A.5.4.21 STT - start/stop toggle
Toggle start/stop equivalent to Start/Stop on main LBA-PC menu.
:STT
A.5.4.22 SYC - synchronize with remote
SYC forces the LBA-PC to wait until data, results, or both have been queried and sent before
capturing another frame. This command is similar to :LOG with the file name set to FRM, RDD,
or RDR, except the LBA-PC does not automatically send the response data.
:SYC <configuration>
3
Key Type Value Description
Data B true = synchronize remote data download
Do not capture another frame until the
controller sends a :FRM? or :RDD?
Command and reads the response data.
false = normal operation