Filter
Top Products
68
• For details on High Speed Sync, refer to the operating instructions supplied with the
flash.
• You can use a flash equipped with a flash sync terminal of the opposite
polarity.
Notes
• Select the manual exposure mode and set the shutter speed to 1/200 second with the
SteadyShot on or 1/250 second with the SteadyShot off. If the shutter speed
recommended on the flash is slower than that, use the recommended speed or an
even slower speed.
• Use a flash with a flash sync voltage of 400 V or less.
• Before you connect the flash sync cord to the (flash sync) terminal, turn off the
power of the connected flash. If the power is on, it may flash when you connect the
cord.
• The flash will always be full emission. Flash compensation (page 73) cannot be
used.
• Using auto white balance is not recommended. Use custom white balance to gain
more precise white balance.
• The flash indicator is not displayed when the (flash sync) terminal is plugged in.
Using a flash equipped with a flash sync terminal cord
Open the cover of the (flash sync)
terminal and plug the cord in.
(flash sync) terminal