Filter
Top Products
Overview
8
When Using an RM-M7G Remote
Control Unit
When an RM-M7G Remote Control Unit is connected
to the CCU-M5A/M5AP, you can control the video
camera with the RM-R7G. The remote control unit
can also be connected directly to the video camera.
When this unit is turned on, the camera is controlled
with the CCU-M5A/M5AP. To control the camera
with the RM-M7G, do the procedure below:
1 Make the following preparations on the CCU-
M5A/M5AP:
• Set the OUTPUT switch on the rear panel to the
appropriate position according to the connected
video equipment.
• Set the CABLE COMP selector according to the
length of the cable.
2 Make the following preparations on the RM-M7G:
• Press the PANEL ACTIVE button.
• Set the CAMERA SELECT switch to “1.”
To control the camera with the CCU-M5A/
M5AP
Press the PANEL ACTIVE button on the CCU-M5A/
M5AP.
Notes
• The PANEL ACTIVE button on the RM-M7G may
not function if you press it while you are operating
this unit. In such a case, complete the operation first,
then press the PANEL ACTIVE button.
• When the DXC-950 series Color Video Camera is
used, the RM-M7G cannot be connected to this unit.