Filter
Top Products
Playback
40
Playing the picture on
a TV
Connect your camcorder via the Handycam
Station or the A/V OUT jack of your
camcorder to a TV using the supplied A/V
connecting cable.
Connect the supplied AC Adaptor to the wall
socket for the power supply (p. 15).
Refer also to the instruction manuals supplied
with the devices to be connected.
To copy to another tape, see page 63.
* By using an S video cable (optional), higher quality
DV format pictures can be produced. When there is
an S video jack on the device to be connected,
connecting the S video cable (optional) to the S
video jacks on both the Handycam Station and the
device instead of using the yellow plug is
recommended. The audio will not be output when
you connect with the S video plug alone.
When your TV is connected to a VCR
Connect your camcorder to the LINE IN input
on the VCR using the A/V connecting cable. Set
the input selector on the VCR to LINE.
When your TV is monaural (When your
TV has only one audio input jack)
Connect the yellow plug of the A/V connecting
cable to the video input jack and connect the
white or the red plug to the audio input jack of
your TV or VCR.
When you want to play the sound in monaural
mode, use a connecting cable (optional) for that
purpose.
If your TV/VCR has a 21-pin connector
(EUROCONNECTOR)
Use the 21-pin adaptor supplied with your
camcorder (For models with the mark
printed on their bottom surfaces only). This
adaptor is designed for output use only.
b Note
• Do not connect the A/V connecting cables to both
your camcorder and the Handycam Station. The
recorded picture may be distorted.
Signal flow
A/V OUT jack
A/V connecting cable (supplied)
VCRs or TVs
Yellow
White
Red
To the audio/video
input jacks
TV/VCR