Filter
Top Products
Dubbing/Editing
Dubbing/Editing
69
To save a program without using it to
record
Touch [ END] in step 9.
The program is stored in memory until the
cassette is ejected.
To erase programs
1
Follow steps 1 to 4 in “Recording the
selected scenes as programs” (p. 67),
then touch [UNDO].
2 Touch [ERASE 1MARK] to delete the
last set program. Or, touch [ERASE
ALL] to delete all the programs.
3 Touch [EXEC].
The programs are deleted.
To cancel this operation, touch [CANCEL].
b Notes
• You cannot set the starting point or ending point on
a blank section of the tape. If there is a blank section,
the total time may not appear correctly.
• When you cannot operate the device correctly using
an i.LINK cable connection, select [IR] in step 9 on
page 65, and set the [IR SETUP] code.