Filter
Top Products
90
Audio dubbing
To play back the new recorded sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by selecting
AUDIO MIX in the menu system.
Five minutes after when you disconnect the power source or remove the battery pack, the
setting of AUDIO MIX returns to the original sound (ST1) only. The factory setting is
original sound only.
To end audio more precisely
First, press ZERO SET MEMORY on the Remote Commander at the point where you want to
stop recording. Then start recording from step 3, and the recording stops automatically near
the counter’s zero point.
If you make all the connections
The audio input to be recorded will take precedence over others in the following order.
•MIC (PLUG IN POWER) jack
•Intelligent accessory shoe
•AUDIO/VIDEO jack
•Built-in microphone
If an i.LINK cable (DV connecting cable) is connected to this unit
You cannot add a sound to a recorded tape.
If you disconnect or connect a cable to the camcorder during recording
The recording may stop.
Notes on audio dubbing
•A new sound cannot be recorded on a tape already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz).
•When an external microphone is not connected, the recording will be made through the
built-in microphone of the camcorder.
•A new sound cannot be recorded on a tape already recorded in the LP mode.
•If you add a new sound on a tape recorded with another camcorder (including DCR-
TRV900), the sound quality may become worse.
•You cannot add audio with the DV IN/OUT jack.
VTR SET
HiFi SOUND
AUDIO MIX
RETURN
[MENU]:END
ST1 ST2