Filter
Top Products
118
Audio dubbing
Monitoring the new recorded sound
(1) Play back the tape on which you added audio.
(2) Turn the SEL/PUSH EXEC dial to select AUDIO MIX in
in the menu
settings, then press the dial.
(3) Turn the SEL/PUSH EXEC dial to adjust the balance between the original
sound (ST1) and the new sound (ST2), then press the dial.
Five minutes after you remove the power supply or the battery pack, the AUDIO MIX
setting returns to original sound (ST1) only. The default setting is original sound only.
Notes
•New audio cannot be recorded on a tape already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz).
•New audio cannot be recorded on a tape already recorded in the LP mode.
•You cannot add audio on the blank portion of the tape.
If an i.LINK cable (optional) is connected to your camcorder
You cannot add audio to a recorded tape.
We recommend that you add audio on a tape recorded with your camcorder
If you add audio on a tape recorded with another camcorder (including another
DCR-TRV940/TRV950), the sound quality may become worse.
If you set the write-protect tab of the cassette to lock
You cannot record on a tape. Slide the write-protect tab to release the write protection.
ST1 ST2
VCR SET
HiFi SOUND
AUDIO MIX
A/VcDV OUT
RETURN
[
MENU
]
:
END