Filter
Top Products
127
Operation Warnings
Chapter 7 Appendix
Error code list
When the error code other than the ones listed above is
displayed, turn off the power and consult your Sony
representatives.
Operation/error messages
An operation or error message is displayed in the
operation/error message display area
(page 22) in the
viewfinder.
Error code Action to take
Er07-*** Turn off the power and consult your Sony
representative.
Or you may be able to eject the cassette using
the following procedure. However, because it
may damage the cassette, any damage is
your responsibility.
When “Warning: SLACK” appears
1 Turn off the camcorder.
This may take about 15 seconds.
2 When the camcorder is turned off, turn it on
again.
3 If the error code disappears, change the
cassette because it may be damaged.
If the error message appears again, turn off
the power and consult your Sony
representative.
When “Warning: CASSETTE” appears
1 Press and hold the STOP button and the
EJECT button at the same time for more
than 3 seconds.
2 When the PLAY button, the REW button,
and the FF button all flash at one time,
release your fingers.
3 If the cassette is ejected, change the
cassette because it may be damaged.
If the error message appears again, turn off
the power and consult your Sony
representative.
Er08-***
Er09-***
Er09-200 Turn off the power and consult your Sony
representative.
Er09-500
Er09-600
Er09-900
Er91-*** Turn off the power and consult your Sony
representative.
Er92-***
Operation/error
message
Meaning
INTERVAL Indicates the camcorder is in the
Interval Rec mode.
LOW LIGHT Appears, depending on the
setting, to indicate the subject
illumination is inadequate.
HIGH TEMPERATURE Indicates the internal temperature
of the camcorder has increased. If
this warning appears, stop the
operation and turn the power of
the camcorder off.