Sony DSR-400L/400PL Camcorder User Manual


 
30
Adjusting the Viewfinder
Chapter 2 Preparation
To use the AC-DN10 AC adaptor
Mount an AC-DN10 on the camcorder in the same way as
a battery pack, then connect to the AC power supply.
The AC-DN10 can supply up to 100 W of power.
Avoiding breaks in operation due to
an exhausted battery
When the battery pack is becoming exhausted, you can
perform battery replacement without causing a break to the
camcorder operation by using an AC adaptor.
1
Turn the AC-550 AC adaptor on.
2
Connect an AC-550 AC Adaptor to an AC power
source, then connect it to the DC IN connector of the
camcorder
(page 29).
The power source switches automatically from the
battery pack to the AC adaptor connected to the DC IN
connector.
There may be some noise on the video signal at the
time of power source switching.
3
Replace the battery pack with a fully charged one.
Adjusting the Viewfinder
Depending on the eyesight of the operator — whether
longsighted or shortsighted — the optimal position of the
viewfinder image varies. Adjusting brightness, contrast,
and so on, improves the visibility of the viewfinder screen.
Although these adjustments may make the viewfinder
image clearer, they have no effect on the output video
signal from the camcorder.
Adjusting the viewfinder position
To adjust the viewfinder left-to-right position, loosen the
left-to-right fixing ring, and to adjust the front-to-back
position, loosen the front-to-back position locking knob.
Adjusting the eyepiece focus and
the screen (brightness, contrast,
and outline emphasis)
Note
to an AC power source
Viewfinder left-to-right position
fixing ring
Viewfinder front-to-back
position locking knob
Eyepiece focusing
knob
BRIGHT control
CONTRAST control
OUTPUT/DCC switch
PEAKING control