Filter
Top Products
Troubleshooting
81
e recording media is full. Delete
unnecessary images (p. 38).
Total number of movies or still images
exceeds the recordable capacity of the
media (p.
62, 92). Delete unnecessary
images (p.
38).
While [DROP SENSOR] (p. 69) is
activated, you cannot record images.
You cannot record images in sleep mode.
Cancel QUICK ON (p.
27).
Your camcorder is recording the image you
have just shot onto the media. You cannot
make a new recording during this period.
e temperature of your camcorder is
extremely high. Turn o your camcorder
and leave it for a while in a cool place.
e temperature of your camcorder is
extremely low. Turn o the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
You cannot record a still image.
You cannot record a still image together
with:
[SMTH SLW REC]
[FADER]
[D.EFFECT]
[PICT.EFFECT]
The ACCESS lamp remains lit even
when you stop recording.
Your camcorder is recording the image you
have just shot on the media.
The recording angle looks dierent.
Recording angle may vary depending on
the condition of the camcorder. is is not
a malfunction.
The ash does not work.
You cannot use the ash when you capture
still images while recording a movie.
Even if auto ash or (Auto redeye
reduction) is selected, you cannot use the
ash with:
NightShot
[SUPER NIGHTSHOT]
[TWILIGHT], [CANDLE],
[SUNRISE&SUNSET], [FIREWORKS],
[LANDSCAPE], [SPOTLIGHT],
[BEACH] or [SNOW] in [SCENE
SELECTION]
[MANUAL] in [EXPOSURE]
[SPOT METER]
The actual recording time for movie is
less than the expected approximate
recording time of the media.
Depending on the recording conditions,
the time available for recording may be
shorter, for example when recording a fast
moving object, etc (p.
58).
The recording stops.
e temperature of your camcorder is
extremely high. Turn o your camcorder
and leave it for a while in a cool place.
e temperature of your camcorder is
extremely low. Turn o the camcorder
and take it to a warm place. Leave the
camcorder there for a while, then turn on
the camcorder.
If vibrations occur continuously, recording
may stop.
There is a time dierence between the
point where you press START/STOP
and the point that movie recording
starts/stops.
On your camcorder, there may be a slight
time dierence between the point where
you press START/STOP and the actual
point that movie recording starts/stops.
is is not a malfunction.
The auto focus does not function.
Set [FOCUS] to [AUTO] (p. 73).
e recording conditions are not suitable
for auto focus. Adjust the focus manually
(p.
73).