Filter
Top Products
80
It is recommended you connect your
camcorder to the wall socket using the
supplied AC Adaptor during the operation.
1 Slide the POWER switch repeatedly to turn
on the PLAY/EDIT lamp.
2 Touch t [MENU] t
(STANDARD SET) t [CALIBRATION]
t .
The screen changes to 16:9 ratio when
using 4:3 ratio.
3 Touch the “×” displayed on the screen with
the corner of the “Memory Stick Duo” or
the like.
The position of the “×” changes.
To cancel [CALIBRATION], touch
[CANCEL] in step 3.
If you did not press the right spot, start from
step
3 again.
b Notes
• You cannot calibrate the LCD screen if it is
rotated.
On handling the casing
• If the casing is soiled, clean the camcorder body
with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
• Avoid the following to avoid damage to the
finish.
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent, insecticide
and sunscreen.
– Handling with above substances on your
hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
About care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances:
– When there are fingerprints on the lens
surface.
– In hot or humid locations
– When the lens is exposed to salty air such as
at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above. It is recommended that you
operate your camcorder about once a month to
keep it in optimum state for a long time.
To remove dust from inside the
viewfinder
1 Pull out the viewfinder.
2 While pushing in the tab on the side
with a fine-tipped implement such as a
ball point pen, pull the eyecup block in
the direction of the arrow to remove.
3 Remove dust from the eyecup block
with a camera blower, etc.
4 Press the viewfinder onto the body of
the camcorder.
CALIBRATION
Touch the "x"
1/3
CANCEL
Tab
Maintenance and precautions (Continued)