Filter
Top Products
HVL-F43AM
4-278-307-11(1) GB
C:\édéñÉtÉHÉãÉ_\ÅiäîÅjÉGÉXÉPÉCÉèÅ[Éh\SO-
NY\VX9197\SourceÉfÅ[É^\4278307111\4278307111\4278307111HVLF58AMUC\01GB-
HVLF58AMUC\060C03.fm
Master: Left
60
Notes on wireless flash
• You cannot use a flash meter or color meter in wireless flash mode because the
pre-flash goes off.
• Test flash for the wireless flash is in the currently selected test flash mode. One
flash occurs with [TEST1] and three flashes with [TEST3]. Flashes continue for
four seconds with [TESTM]. For details of test flash, See “Custom settings”
(page 63).
• The zoom position for the HVL-F43AM is automatically set to 24 mm. A zoom
position other than 24 mm is not recommended.
• In wireless flash mode, ADI metering is canceled and P-TTL flash metering is
used automatically (page 26).
• Multiple flash cannot be used.
• If another wireless flash is being used nearby, you can change the channel in the
custom settings to prevent interference (page 63).
• When photographing with the wireless flash, the flash unit may in rare cases go
off by mistake due to ambient static electricity or electromagnetic noise.
When the flash is not in use, select [ ] using the MODE button.
• The flash unit may in rare cases provide incorrect luminescence because the
signal light does not reach the subject, etc,. due to the position in which the
wireless flash was installed. In this case you can prevent incorrect luminescence
by changing the installation position of the wireless flash or changing the
wireless channel setting in the custom settings (page 63).
• You can use several off-camera flashes at the same time.
• The off-camera flash fires with the power level set in each flash when the off-
camera flash is in the MANUAL mode.