Filter
Top Products
7-GB
GB
For DCR-TRV6E/TRV11E/TRV15E/TRV17E/TRV20E/TRV30E
Use camera mounting shoe B and D, cushions for camera mounting shoe D and the
screw plate.
Before attaching the camcorder
Check the cushions for camera mounting shoe D and the installing position of the
screw plate for your camcorder against the table below.
Camera Camera
DCR- mounting mounting Cushion
shoe B shoe D
TRV6E/TRV11E 2 2 Thin
TRV15E/TRV17E 2 3 Thin
TRV20E 2 1 Thin
TRV30E 2 1 Thick
Remove the stick tape from the
cushion for camera mounting shoe
D. Then stick the cushion for
camera mounting shoe D onto
camera mounting shoe D as shown
in the illustration.
1 Attach the screw plate to the
position on shoe D so that the
catch on the reverse side of the
shoe D clicks into place.
The installing position of the
screw plate differs on your
camcorder. For details, refer to
the table above.
2 Fasten the screw of the screw
plate on shoe D to the tripod
screw hole of the camcorder and
tighten firmly.
3 Attach the screw plate to the
position 2 on shoe B.
4 Fasten the screw of the screw
plate on the shoe B to the screw
hole on the shoe D of the
camcorder tightly.
5 Connect the A/V cable of the
shoe to the camcorder’s
AUDIO/VIDEO jack.
continued
Camera mounting
shoe D
Camera mounting
shoe B
Screw plate
Installation
position
of the screw plate
of the camera
mounting shoe D
Screw plate