Filter
Top Products
Picture Profiles
86
Recording
Confirm that the corresponding ACCESS
lamp is lit in green.
3 Select the picture profile to be stored.
The selected picture profile number is
displayed at the bottom of the screen.
See “Selecting a Picture Profile using the
PICTURE PROFILE menu” on page 84.
4 Select “SET” of the PICTURE
PROFILE menu.
5 Select “Store” of “PP Data.”
The message “PP Data Store Execute/
Cancel” is displayed at the bottom of the
screen.
6 Select “Execute.”
Writing of the selected picture profile to the
memory card begins.
When writing ends, the completion message is
displayed for three seconds, and the original
screen display is restored.
Note
After you start writing, do not remove the SxS
memory card until the completion message is
displayed.
Loading a Picture Profile
1 Set the power switch to CAMERA.
The camcorder is turned on in Camera mode.
2 Insert the SxS memory card that
contains the picture profile to be loaded
into a slot.
Confirm that the corresponding ACCESS
lamp is lit in green.
3 Select the picture profile for which the
picture profile is to be loaded from the
memory card.
The selected picture profile number is
displayed at the bottom of the screen.
See “Selecting a Picture Profile using the
PICTURE PROFILE menu” on page 84.
4 Select “SET” of the PICTURE
PROFILE menu.
5 Select “Recall” of “PP Data.”
The message “PP Data Recall Execute/
Cancel” is displayed at the bottom of the
screen.
6 Select “Execute.”
Loading of the picture profile from the
memory card begins.
When overwriting to the picture profile you
specified in step 3 ends, the completion message
is displayed for three seconds, and the loaded
settings are immediately reflected.
Note
After you start loading, do not remove the SxS
memory card until the completion message is
displayed.
P
I
CTURE
PROF
I
LE
PP
1:
STANDARD
Black
Black
G
a
mm
a
Low Key Sat
C
opy
PP
D
ata
R
eset
Store
R
ecall
SEL
SET
:
0
:
0
:
0
B
B