Filter
Top Products
26
DCR-HC17E/HC19E/HC21E/HC22E 2-586-501-11(1)
Searching for the starting point
Make sure that the CAMERA lamp lights
up.
Searching for the last scene of the
most recent recording (END SEARCH)
[END SCH] (END SEARCH) will not
work once you eject the cassette after you
have recorded on the tape.
Touch [PAGE1], then touch
[END SCH].
0:00:00
SPOT
FOCUS
FOCUS
MENU FADER END
SCH
EXPO–
SURE
SPOT
METER
DISP
GUIDE
PAGE1 PAGE2
60min
Touch here again to cancel the operation.
The last scene of the most recent
recording is played back for about 5
seconds, and the camcorder enters the
standby mode at the point where the last
recording has finished.
• [END SCH] will not work correctly when
there is a blank section between recorded
sections on the tape.
• When the PLAY/EDIT lamp lights up, you
can do this operation.
Searching manually (EDIT
SEARCH)
You can search for the start point to start
the next recording while viewing the
pictures on the screen. The sound is not
played back during the search.
1 Touch [PAGE1]
[MENU].
2 Select (CAMERA SET) with
/ , then touch [EXEC].
3 Select [EDITSEARCH] with
/ , then touch [EXEC].
4 Select [ON] with / , then
touch [EXEC] .
0:00:00STBY60min
EDIT
FN
5 Touch and hold (to go
backward)/ (to go forward)
and release it at the point where
you want the recording to start.
Reviewing the most recently
recorded scenes (Rec review)
You can view a few seconds of the scene
recorded just before you stopped the tape.
1 Touch [PAGE1]
[MENU].
2 Select (CAMERA SET) with
/ , then touch [EXEC].
3 Select [EDITSEARCH] with
/ , then touch [EXEC].
4 Select [ON] with / , then