Filter
Top Products
Getting started
Getting started
11
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (L series) to
the AC Adaptor/charger.
b Note
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (L series) (p. 117).
• Do not short-circuit the DC plug of the AC Adaptor/
charger with any metallic objects. This may cause a
malfunction.
• Use a nearby wall outlet when using the AC
Adaptor/charger. Disconnect the AC Adaptor/
charger from the wall outlet immediately if any
malfunction occurs.
1 Set the mode switch to CHARGE.
2 Connect the power cord to the AC
Adaptor/charger.
3 Connect the power cord to the wall
outlet.
4 While pressing the battery back down,
slide it in the direction of the arrow.
The charge lamp lights up and charging
starts.
When the battery was successfully
charged
The battery mark on the display window will
light up in the shape of a full battery ( ) that
indicates that the battery has been sufficiently
charged for use.
If you continue charging until the CHARGE
lamp turns off and FULL appears on the display
window, the battery has now been fully charged
and can be used for a little longer period.
Remove the battery pack from the AC Adaptor/
charger.
To attach the battery pack to the
camcorder
Press the battery pack and slide it down.
To remove the battery pack
1
Set the POWER switch to OFF.
To the wall outlet
Power cord
AC Adaptor/charger
Battery pack
Mode switch
Charge lamp
Display window
,continued