Filter
Top Products
38
Using the fader function
(1) When fading in [a]
In the standby mode, press FADER until the desired fader indicator flashes.
When fading out [b]
In the recording mode, press FADER until the desired fader indicator flashes.
The indicator changes as follows:
FADER t M.FADER t BOUNCE t MONOTONE t OVERLAP t
WIPE t DOT
The last selected fader mode is indicated first of all.
(2) Press START/STOP. The fader indicator stops flashing.
After the fade in/out is carried out, your camcorder automatically returns to
the normal mode.
To cancel the fader function
Before pressing START/STOP, press FADER until the indicator disappears.
Notes
• The overlap, wipe and dot functions work only for tapes recorded in the Digital8
system.
• You cannot use the following functions while using the fader function. Also, you
cannot use the fader function while using the following functions:
– Digital effect
– Low lux mode of PROGRAM AE (Overlap, wipe, or dot function only)
– Super NightShot
– Tape photo recording
Before operating the overlap, wipe, or dot function
Your camcorder stores the image on the tape. As the image is being stored, the indicator
flashes quickly, and the image you are shooting disappears from the screen. Depending
on the tape condition, the image may not be recorded clearly.
Note on the bounce function
You can use this function when D ZOOM is set to OFF in the menu settings.
1
FADER
FADER