Filter
Top Products
Chapter 6 Menu Displays and Detailed Settings
93
6-2 Status Display on the Viewfinder Screen
4
Carry out setting operations as follows.
1 Turn the MENU knob to move the b mark to
“GENLOCK”, and press the MENU knob.
The b mark on the left of “GENLOCK” changes to
a z mark and the z mark on the left of the
GENLOCK setting changes to a ? mark.
2 Turn the MENU knob until ”OFF” appears, then
press the MENU knob.
The z mark on the left of “GENLOCK” changes
to a b mark and the ? mark on the left of the
GENLOCK setting changes to a z mark, and the
setting is executed.
3 Turn the MENU knob to move the b mark to
“RETURN VIDEO”, and press the MENU knob.
The b mark changes to a z mark and the z mark
changes to a ? mark.
4 Turn the MENU knob until “ON” appears, then
press the MENU knob.
The z mark changes to a b mark and the ? mark
changes to a z mark, and the setting is executed.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
To see the image of the return video signal
on the viewfinder screen
Hold down the RET switch on the lens. The image of the
return video signal input to the GENLOCK IN connector
is displayed on the viewfinder screen while you are
holding down the RET switch.
When the return video function is assigned to the ASSIGN
1/3/4 switch, you can see the image of the return video
signal on the viewfinder screen while you are holding
down the ASSIGN 1/3/4 switch even if the RETURN
VIDEO item is set to “OFF” on the GENLOCK page of the
MAINTENANCE menu.
Note
When no signal is input to the GENLOCK IN connector,
the image is not changed even if you hold down the RET
switch on the lens.
However, the image is switched while you are holding
down the ASSIGN 1/3/4 switch to which the return video
function is assigned, even if no signal is input to the
GENLOCK IN connector.
M15 MAINTENANCE
GENLOCK : ON
RETURN VIDEO : OFF
GL H PHASE : 0
GL SC PHASE : 0
GL SC 0/180 SEL : 180
TOP