Filter
Top Products
29
IP Camera User’s Manual Speco Technologies
connect to THE CAMERA by Domain Name (Server Name) allocated to THE CAMERA.
For example, run Web Browser and input Domain Name allocated to THE CAMERA in URL.
In http://IPINTB1.ipcam4u.net , ‘IPINTB1’ is to be Name of Server registered in Service
Server by user.
If the initial page is shown, check Video of THE CAMERA referring to ‘2. Install and
Video Check’. If Video is seen, set up is properly done.
3.4. Cautions
If the firewall is used for security purpose, THE CAMERA may not work properly. In this case, open
the port of THE CAMERA, then it will work properly. The port being used by THE CAMERA can be
checked
on ‘Port Setting’ of ‘Network Setting’ of ‘Administrator’s Page’.
Port of THE CAMERA on ex-factory is set default as follows ;
Web Connection Port: Port 80 TCP
Authentication and Control Port: Port 9000 TCP
Video Streaming Port: Port 9001 TCP
Motion Detection Control Port : Port 9005 TCP
In setting user port, do not use 1504, 1508, which port is used in THE CAMERA itself.