Filter
Top Products
2-26
2.3.4 Date Setting
This section tells you how to setup IP device’s date and time settings.
z STEP 1: Click the [Date Setting] on the “Main Setup page”.
The “Date setting page” is displayed as below
z STEP 2: Configure these settings with reference to the table below. If
you are still unsure what to set, contact your system administrator.
■Date Setting
Parameters Description
SNTP/NTP
server
Click this to enable IP device’s SNTP/NTP function.
SNTP/NTP function enables this video to synchronize its time
settings with a SNTP/NTP server. You can use this function to
make sure all your IP devices’ time is the same. Additionally,
with our embedded digital-time-code in the streaming, you can
tell the event sequence accurately.
IP address: Enter the IP address of the SNTP/NTP
server.
Sync time: Select the time interval for this IP device
to synchronize its time.
Set manually
Click this to manually setup the date & time.
Date : Select the date
Time: Select the time
Time zone
Select the time zone offset for local settings
Day Light Saving
Select Type 1 to specify daylight saving time by week