Filter
Top Products
PI1000
7
SVAT ELECTRONICS
now you can see
PI1000 SETUP
PI1000 SETUP
1. The power switch is situated on the top of the device.
NOTE: Each time the PI1000 is powered on, the system auto-detects the SD card.
When the REC LED flashes, it indicates that the system is testing the SD card
(complete boot time is several seconds). If a video file error has been detected, the
system will initiate auto repair.
2. After power on, the system auto enters live monitoring. If the system was previously
set to scheduled or motion activated recording, it may auto-enter record mode.
3. The icon shown on the status line, indicates that the SD card is
operating normally.
4. If there is a problem/error with the SD card, the Record or Playback LEDs will not light
up when the Record or Play buttons are pressed. Instead, the Play, Menu, and Rec
LEDs will flash quickly. Please re-format the SD card before proceeding.
5. When the SD card is writing data during recording, the record LED will flash slowly.
6. After a power outage, the system auto-returns to the previous recording mode.
7. Tip: To quickly format the SD card, turn the DVR off. Then hold the and
buttons and switch the DVR on. A “Format OK” message will be displayed when the
SD card is successfully formatted.
6.2. MONIT
6.2. MONIT
ORING MODE
ORING MODE
Immediately after bootup, monitoring mode is displayed, with the following status
indicators:
1. Time Display: System Date and Time.
2. Record Status Display: Manual Record Parameter.
Record Resolution, please refer to (7.4 Record Setup) for VIDEO SIZE setup.
Record Quality, please refer to (7.4 Record Setup) for VIDEO QUALITY
setup.
1.
2.
3.