Filter
Top Products
TANDBERG Videoconferencing System
39
General use
Disconnecting sites from a conference
To disconnect a site or end the conference, press DISCONNECT.
• Select site and press OK or ‘Disconnect Site’.
To end the meeting press ‘Disconnect All’.
disconnect
EACH SYSTEM WILL BE IDENTIFIED BY A
SYSTEM NAME (IF SUPPORTED) AND THE
NUMBER OF THE FAR END.
Adding an extra site - dial in
To dial in to the MultiSite on ISDN-BRI:
• Site 2 must dial MultiSite Number 2.
• Site 3 must dial MultiSite Number 3.
To dial in to the MultiSite on ISDN-PRI:
• Dial the main number of the system (‘My ISDN Number’). All sites can dial the same number.
To dial in to the MultiSite on IP:
• Dial the IP Number or the IP Address of the system (‘My IP Number’/‘My IP Address’).
When the MultiSite receives an incoming call, the following menu is displayed:
• Pressing CONNECT is equivalent to pressing ‘Accept’.
• Pressing DISCONNECT is equivalent to pressing ‘Reject’.
• Pressing ‘Do Not Disturb’ will disable the MultiSite from answering more incoming calls during the current
conference. The calling party will receive a busy signal.
TO FIND THE DIAL-IN NUMBERS FOR THE MULTISITE,
PRESS ‘MENU’ AND ‘SYSTEM INFO’
TIP
NOTE